当前位置: 产品列表 产品详情
< >

0.42'' I2C OLED液晶屏

SCE042001-V01是一款COG型OLED显示屏,72×40分辨率,SSD1306BZ芯片,4线串行接口I2C,16PIN

  • Type: OLED
  • Mode: -
  • Product No: SCE042001-V01
  • Size: 0.42"
  • Resolution: 72*40
  • Outline Dimension: 12*11*1.227
  • Active Area: 9.196*5.18
  • Interface: 4-wire
  • IC: SSD1306BZ
  • Brightness: -
  • Touch Screen: No
  • View Direction: -
  • Pin No: 16
  • Shape: 长方形
立即询价

介绍:

 General Specification

 

ITEMSPECIFICATIONSUNIT
 MODULE SIZE12.0(W)x11.0(H)x1.227(D)mm
 VIEWING AREA10.196 (W) x 6.18(H)mm
 ACTIVE AREA9.196 (W) x5.18 (H)mm
 DOT SIZE0.108(W) x0.11(H)mm
 DOT PITCH0.128(W) x0.13 (H)mm
 ASSY.TYPECOG
 WEIGHTTBD

 

 Interface Definition

 

PIN NO.SYMBOLTYPEFUNCTION DESCRIPTIONS
1C2PIC1P/C1N-Pin for charge pump capacitor.
C2P/C2N-Pin for charge pump capacitor.
Connect to each other with a capacitor. They must be floated when the
Charge pump not use.
2C2N
3C1P
4C1N
5VBATPPower supply for charge pump regulator circuit.
It must be connected to external source when charge pump is used.
It must be float when charge pump is not used.
6VSSPGround pin. It must be connected to external ground.
7VDDPPower pin for logic circuit. It must be connected to external source.
8BS1IInterface selection pins.
I2C 4SPI
BS1 1 0
9CS#IChip Select input pin. Active “L”
10RES#IHardware reset input pin. Active “L”.
11D/C#IThis is Data/Command control pin.
When the pin is pulled HIGH, the data at D[7:0]  is data. When the pin is pulled LOW, the data at D[7:0] is command. In I2C mode, this pin acts as SA0 for slave address section.
When 3-wire serial interface is selected, this pin must be connected to VSS
12D0
When serial interface mode is selected, D2 should be kept NC, D1 will be the serial data input: SDIN, D0 will be the serial clock input: SCLK.
When I2C mode is selected, D2, D1 should be tied together and serve
as SDA and D0 is the serial clock input, SCL.
13D1
14D2I/O
15VCOMHOCOM signal deselected voltage level.
A capacitor should be connected between this pin and VSS.
16VCCPPower supply for OLED driving voltage. A capacitor should be connected between this pin and VSS, when charge pump is used.
It must be connected to external source when charge pump is not used.


下一个产品 : 0.49" 64x32 OLED显示屏 下一页